The DAT 100/RS485 product is a weight transmitter which guarantees high performance and long-term reliability. Its small width makes it possible to position a large number of transmitters inside the electrical automation panels. DAT 100/RS485 weight transmitter has an interface with intrinsically safe barriers for use in hazardous areas. It has two red status LEDs, 3 mechanical buttons behind the red door and screw terminal blocks. PWS: 37/2015
Technical Specifications in PDF
| Measuring range: –4 ÷ +4 mV/V |
| Input sensitivity: 0.02 µV/count |
| Full scale non-Linearity: < 0.01% |
| Gain drift: < 0.001% FS/°C |
| Display: 5 digit, red LED (7 segments), h 7 mm |
| A/D Converter: 24 bit |
| Internal Resolution: > 16.000.000 points |
| Trasducer input voltage: 4 V (max 4 cells 350 Ohm) |
| Frequency signal acquisition: 4 ÷ 123 Hz |
| Visible resolution (in divisions): 999999 |
| Divisions value (adjustable): 0.001 ÷ 50 |
| Temperature range: -10 ÷ +50°C (max umidity 85% without condensation) |
| Storage temperature: -20 ÷ +60°C |
| Filter: 0.2 ÷ 25 Hz |
| Serial port: RS232C half duplex with ASCII or Modbus RTU protocol, RS485 full duplex with ASCII or Modbus RTU protocol |
| Power supply: 24 V c.c. ±10% – power 2 W |
| Regulatory compliance: EN61000-6-2, EN61000-6-3 for EMC; EN61010-1 for electrical security |
| Baud rate: 2400 ÷ 115200 adjustable |
| Transmission distance: 15 m (RS232); 1000 m (RS485) |
deutsch
français
español
italiano
हिन्दी
