The Model 1042 is a low proile single-point load cell designed for direct mounting in weighing platforms. Its small physical size, combined with high accuracy and low cost, makes this load cell ideally suited for retail, bench and counting scales. Capacities of 5 kg and above are supplied as standard in anodized aluminum. This high accuracy load cell is approved to NTEP and other stringent approval standards, including OIML R60. A humidity resistant protective coating assures long-term stability over the entire compensated temperature range. The two additional sense wires feed back the voltage reaching the load cell. Complete compensation of changes in lead resistance due to temperature change and/or cable extenstion, is achieved by feeding this voltage into the appropriate electronics. PWS: 09/2019
Technical Specifications in PDF
| Rated Load (RL): 1*, 3, 5, 7, 10, 15, 20, 30, 50, 75, 100, 150**, 200* ** kg * no OIML; ** no NTEP |
| Ultimate overload: 300 % RL |
| Material: Plated (anodize) aluminium |
| Degree of protection: IP66 |
| Compensated Temperature: -10 ÷ +40°C |
| Temperature range: -30 ÷ +70°C |
| Temperature effect on zero balance: ±0.0014 % (NTEP); ±0.0100 % (Non Approved); ±0.0023 % (C3); ±0.0014 % (C6); RO/°C |
| Temperature effect on output: ±0.0010 % (NTEP); ±0.0030 % (Non Approved); ±0.0010 % (C3); ±0.00058 % (C6); RO/°C |
| Rated output RO: 2 mV/V |
| Zero balance: ±0.20 mV/V |
| Insulation resistance: > 2000 MOhm |
| Input impedance: 415±20 Ohm |
| Maximum input voltage: 15 Vdc or Vac rms |
| Nominal input voltage: 10 Vdc or Vac rms |
| Cable Lenght: 1 m |
| Load plan: 400x400 |
| Output impedance: 350±3 Ohm |
deutsch
français
español
italiano
हिन्दी
